Anthem MRX 310 Manuel d'utilisateur télécharger pdf (Page 7)

Once you have installed the ARC 2 software, you then enter the distances to your speakers in the

Listener Position sub-menu. You can choose between feet and metres and the increments are 1

foot or 0.3 metres. Once that is done, all you need to do is connect the microphone to a USB port

on your laptop, connect the MRX 710 to your network and place the microphone in the sweet spot

using the provided tripod stand. ARC 2 has both an automatic mode and a manual mode but for

most people the automatic mode will be the best option. You just run the automatic version of

ARC 2 and follow the instructions. The software looks for the receiver on the network and checks

the microphone and the support file match. This is because each microphone’s frequency response

is measured precisely in the factory and then used to create the calibration file.

ARC 2 is the best auto-calibration and room

EQ software that we have experienced on any

AV receiver.

The automatic version of ARC 2 will take you through the entire process, beginning with selecting

the number of speakers and the configuration. Then you can select the number of measurement

positions, the system defaults to five but you can go up to nine. ARC 2 then begins measuring at

the first position before promoting you to move the microphone to the second position and

measuring again. The software will do this for all the positions you have requested and once all

the measurements have been taken, ARC 2 processes the data and uploads it to the hard drive on

1 2 3 4 5 6 7 8

Pas de commentaire

Anthem MRX 310 Manuel d'utilisateur Page 7