Anthem AVM 50v 3D Manuel d'utilisateur télécharger pdf (Page 24)

3. SETUP continued …

SETTING UP THE PROCESSOR

Upon entering the setup menu your display will show the menu below. Only 8 menu items can be displayed

at once – for clarity this manual shows each menu with all its items. On-screen display is recommended

although the front panel shows similar information, one item at a time. If the default video output settings do

not work with your display, use the front panel display to set video output. Setup menus are displayed

through MAIN HDMI and Component (processed) outputs, and MAIN and ZONE2 S-Video outputs, whereas

the 2-line status display and the video processing menu are displayed as follows:

MAIN on-screen display is available via HDMI1 output by default. On-screen display comes from HDMI2 and

Component (processed) if “Preferred” is changed to “Component” in menu 1 submenus. S-Video on-screen

display is available in both cases.

ZONE2 on-screen display is available via S-Video output.

To go to a submenu, highlight a menu item and press SELECT. Each on-screen menu also has a scrolling help

line at the bottom as shown above.

3.1 VIDEO OUTPUT

Highlighting VIDEO OUTPUT then pressing SELECT displays this menu:

ANTHEM AVM 50v SETUP

1. VIDEO OUTPUT

2. SET TIME / TIMERS

3. SPEAKER CONFIG

4. LISTENER POSITION

5. LEVEL CALIBRATION

6. SOURCE SETUP

7. MODE PRESETS

8. ANALOG INPUT LEVELS

9. ADC / AUDIO OUTPUT

10. VOLUMES / PATH NAMES

11. TRIGGER / IR / RS232

12. DISPLAYS / TIMEOUT

13. SAVE / LOAD SETTINGS

14. LOCKOUT / PASSWORDS

SELECT Enters Submenu

1. VIDEO OUTPUT

a. VIDEO OUT CONFIG 1

b. VIDEO OUT CONFIG 2

c. VIDEO OUT CONFIG 3

d. VIDEO OUT CONFIG 4

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 101 102

Pas de commentaire

Anthem AVM 50v 3D Manuel d'utilisateur Page 24