Anthem AVM 50v 3D Manuel d'utilisateur télécharger pdf (Page 52)

3.13 SAVE / LOAD SETTINGS

Two memories can back up menu settings. If your system was set up by your dealer, the settings may be

saved in Installer memory. You can make further adjustments – save those settings in User memory. Video

processor settings (section 4.11) and FM • AM presets are also saved.

Save and Load Settings:

When saving or loading settings, the processor will prompt you to confirm that you want to replace the

current settings – press BACK at this point if you don’t want to make the changes.

To clear adjustments described in sections 4.6 and 4.7, save User Settings, then load Factory Defaults,

then load User Settings. The Setup will remain as it was. If certain channels don’t sound as loud as they

should under certain conditions, and you have calibrated levels according to section 3.5, try this before

contacting technical support. The cause may just be a forgotten adjustment, or an adjustment that

someone else made and didn’t tell you. Happens sometimes!

Example 1: Save User Settings.

• Enter the setup menu. Go to SAVE / LOAD SETTINGS and press SELECT.

• Upon entering this menu item, SAVE USER SET’NS will be highlighted in red.

• Press SELECT. You will be asked to confirm that you want to over-write current settings.

• Use the 34 buttons and change to Yes. If you are using a Password, you will be asked for it. Use

the 0 – 9 buttons to enter your Password. The on-screen display will say Saving Successful and the

front panel will say Done.

Example 2: Load Installer Settings.

• Enter the setup menu. Go to SAVE / LOAD SETTINGS and press SELECT.

• Press the 6 button until you reach LOAD INSTALLER SET’NS.

• Press SELECT. You will be asked to confirm that you want to restore installer settings.

• Use the 34 buttons to change to Yes and press SELECT. The on-screen display will say Installer

Settings Loaded and the front panel will say Done.

Example 3: Load Factory Defaults.

• Enter the setup menu. Go to SAVE / LOAD SETTINGS and press SELECT.

• Press the 6 button until you reach LOAD FACTORY DEFAULTS.

• Press SELECT. You will be asked to confirm that you want to load factory settings.

• Use the 34 buttons to change to Yes and press SELECT. The on-screen display will say Factory

Defaults Loaded and the front panel will say Done.

3. SETUP continued …

13. SAVE / LOAD SETTINGS

a. SAVE USER SETTINGS

b. LOAD USER SETTINGS

c. SAVE INSTALLER SET'NS

d. LOAD INSTALLER SET'NS

e. LOAD FACTORY DEFAULTS

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 101 102

Pas de commentaire

Anthem AVM 50v 3D Manuel d'utilisateur Page 52